Altera Arria II GX FPGA - Manual (Page 26)

6–6 Chapter 6: Board Test System
Using the Board Test System
Arria II GX FPGA Development Kit User Guide February 2011 Altera Corporation
■ PSR —Sets the MAX II PSR register. The numerical values in the list corresponds to
the page of flash memory to load during FPGA reconfiguration. Refer to Table 6–1
for more information.
■ PSS —Displays the MAX II PSS register value. Refer to Table 6–1 for the list of
available options.
■ OCR1 —Sets the MAX II OCR1 register. Refer to Table 6–1 for the list of available
options.
■ SRST —Resets the system and reloads the FPGA with a design from flash memory
based on the other MAX II register values. Refer to Table 6–1 for more information.
1 Because the Config tab requires that a specific design is running in the FPGA at a
specific clock speed, writing a 0 to SRST; writing a 1, 2, or 3 to OCR2; or changing the
PSO value can cause the Board Test System to stop running.
JTAG Chain
This control shows all the devices currently in the JTAG chain. The Arria II GX device
is always the first device in the chain.
1 Uninstalling the shunt jumper from jumper J9 pins 1-2 includes the MAX II device in
the JTAG chain.
Board Information
This control displays static information about your board.
■ MAX-II rev —Indicates the version of MAX II code currently running on the
board. The MAX II code resides in the dir>\kits\arriaIIGX_2agx125_fpga\examples directory. Newer revisions of this
code might be available on the
Arria II GX FPGA Development Kit page of the
Altera website.
■ MAC —Indicates the MAC address of the board.
Flash Memory Map
This control shows the memory map of the flash memory device on your board.