DMP Electronics Security Control Receiver SCS-1R - Manual (Page 37)

Digital Monitoring Products SCS-1R Installation Guide
32
OPERATOR’S GUIDE
SCS-104 Check-in Table Settings
Check-in Table IP Address
The optional SCS-CTM Check-in Table Manager software is used to backup
the records of supervised network accounts on up to 32 different SCS-
104 line cards. Use SCS-CTM to repopulate the list of supervised network
accounts when one SCS-104 or SCS-101 line card is replaced by another
SCS-104 or SCS-101. Additionally, the list of supervised network accounts used by an SCS-104 or SCS-101 on a
primary receiver can be mirrored by the SCS-CTM for use by an SCS-104 or SCS-1011 card on a second receiver.
Refer to the SCS-CTM User’s Guide (LT-0940).
Note: The list of supervised network accounts on an SCS-104 line card is automatically populated as each panel
sends its supervisory check-in message to the SCS-104 line card.
Enter the IP address for the computer where the SCS-CTM Check-in Table Manager software is installed. When no
SCS-CTM software is installed, leave the IP address set to 000.000.000.000.
Check-in Table Port
Enter the IP port used to communicate Check-In Table messages to the SCS-CTM Check-in Table Manager program.
Valid range is 1 to 65,535. Default is 2005.
Check-in Table ID
Enter the table ID number to be used by the SCS-CTM Check-in Table Manager to identify the check-in table. Valid
range is 1 to 255. Default is 1.
Host Automation
The SCS-1R Host Automation programming section allows adjustments to optimize the SCS-1R performance with
the host automation computer.
Host Name
Enter a Host Name up to 16 characters.
Host Port Type
Select Serial to send messages to the host automation computer through the Host Output serial port. Select
Network to send messages through the network connection on the SCS-150 to the host automation computer.
Default is Serial.
Host IP Address
Enter the Host IP Address. This is the IP address of the host automation computer. The default value is
192.168.000.250.
Host Port
The Host Port identifies the port on the host automation computer. Valid range is 1 to 65,535. The default value
is 2001.
Protocol
Select TCP to communicate with the host automation computer over the network using TCP protocol. Select UDP
to communicate using UDP protocol. Default is TCP.