DMP Electronics Security Control Receiver SCS-1R - Manual (Page 16)

SCS-1R Installation Guide Digital Monitoring Products
11
INSTALLATION
Model SCS-104 Line Card
Description
The SCS-104 provides four digital dialer (DD) lines and a network connection for communication to DMP panels.
Each card includes one shielded eight-pin modular connector (J1) for the digital data network connection. This
allows the SCS-1R Receiver to accept alarm and system messages over a network from DMP panels. Each card
also includes a non-shielded eight-pin modular connector (J3) that supports up to four digital dialer lines, when
connected to a standard RJ61 jack.
An optional PC software application, SCS-CTM Check-in Table Manager, is available to backup the SCS-104 records of
all supervised network accounts for up to 32 different SCS-104 line cards. The SCS-CTM program is compatible with
SCS-104 Version 100 or higher. For complete operation information, refer to the SCS-CTM User’s Guide (LT-0940).
Contact DMP Customer Service to purchase a copy of the SCS-CTM Check-in Table Manager software.
Installing the SCS-104
Install the SCS-104 in any one of the SCS-RACK positions with the card puller in the up position. Connect the
10-position flat cable from the SCS-150 processor card. The line card number is determined by the processor card
cable it is connected to.
THE LIGHT BROWN (PIN 1) WIRE OF THE FLAT CABLE CONNECTOR MUST FACE UP ON THE LINE CARD.
Connecting the Phone Lines
Install the phone line cable between the connector on the line card front to the customer supplied RJ61 jacks.
Use a standard 103J voice grade
(analog) line. A slot is provided
in the receiver back plate for the
cables to pass through. Maximum
line impedance is 100 Ohms.
The SCS-104 is registered with
the FCC, registration number
CCKCN03BSCS-104; Ringer
Equivalence 0.3B.
Connecting the Network
Connect an IP network cable between the J1 Ethernet connector on the front
of the line card and the network LAN/WAN connection. Maximum line impedance is 100 Ohms. The SCS-104
automatically communicates UDP or TCP with DMP panels, and iCOM SL Network Alarm Communicators.
Phone Line Monitor
The SCS-104 monitors incoming phone line voltage. During a loss of phone line voltage, the SCS-104 sends a
Warning: Phone Line Trouble message to the host automation or LCD display.
Power Monitor LED
The green LED labeled PWR lights when the power supply on the line card is working properly.
SCS-104 LED Indicators
The SCS-104 provides eight LEDs on the card. The table below describes the LED operation.
LED
Description
Solid Flashing Off
POWER Power On N/A Power Off
DTR Data Terminal Ready N/A Processor is nearly full
LINE 1 Connected Ringing Idle
LINE 2 Connected Ringing Idle
LINE 3 Connected Ringing Idle
LINE 4 Connected Ringing Idle
LINK Indicates a valid Network connection Indicates a valid Network connection No Connection
LINK SPEED Connected at 100 Base-T N/A Connected at 10 Base-T
SCS-104 Line Card
Red
Black
J8
Ethernet J1
Phone
Line
J3
Power
DTR
Line 1
Line 2
Line 3
Line 4