DMP Electronics Security Control Receiver SCS-1R - Manual (Page 34)

SCS-1R Installation Guide Digital Monitoring Products
29
OPERATOR’S GUIDE
Local IP Address
Enter the Local IP Address. This is the SCS-150 IP address used for Web Programming and Net Host Output. The
Local IP Address must be unique and cannot be duplicated. The default value is 192.168.000.250.
Local Port
The Local Port identifies the port used for the Net Host Output connections. If a setting change is required, enter
the new number. Valid range is 1 to 65,535. The default value is 2001.
Gateway Address
Enter the local Gateway Address. The Gateway Address is needed if subnets are divided in your network. The
default value is 000.000.000.000.
Subnet Mask
Enter the local SUBNET MASK assigned to the SCS-150. The default value is 255.255.255.000.
Web User Name
Enter a User Name for web programming access. This is the User Name entered to gain access to the programming
and can be up to 10 characters long. Default is “NEW”.
Web Password
Enter the password to use for web programming access. This is the password used to gain access to the programming
and can be up to 10 characters long. Default is “NEW”. If the password is forgotten, a new password can be entered
at the keypad only.
Print Operation
This section assigns the printing operation and the activity log baud rate.
Print Operation
Select the printer operation. Default is Always.
Print Operation Function
Never Suppresses all printing
Always Prints all messages from the receiver
Primary Fail (Host Output) Prints only when the communication to the primary host fails
Note: If Print Operation is set to Always or Primary Fail, ensure that a printer is connected to the printer port.
Activity Log Baud Rate
Select the baud rate for the Serial Printer port. Default is 1200. Select 300, 600, 1200, 2400, 4800, 9600, 19200, or
38400.