DMP Electronics Security Control Receiver SCS-1R - Manual (Page 23)

Digital Monitoring Products SCS-1R Installation Guide
18
OPERATOR’S GUIDE
LCD Membrane Keypad Configuration
User Options
The keypad provides three adjustments to suit the environment.
To access, press and hold the Back Arrow and COMMAND keys for two seconds. The keypad display changes to
SET BRIGHTNESS. Use the COMMAND key to display the next Option or press the Back Arrow key to exit the User
Options function.
SET BRIGHTNESS
<
      
>
Brightness
Set the keypad LCD brightness level and the AC Power LED. Use the left Select key
to lower the keypad brightness and the right Select key to raise the brightness. The
LCD backlighting turns on every time a key is pressed or the speaker sounds. The
backlighting dims to medium brightness whenever the speaker is on.
Note: If the brightness level is lowered, it reverts to maximum intensity whenever a
key is pressed. If no keys are pressed, and the speaker has not sounded for 30 seconds,
the user-selected brightness level restores.
SET TONE
<
      
>
Speaker Tone
The keypad speaker emits standard tones for key presses and alerts. At the SET TONE
display, use the left Select key to lower the tone and the right Select key to raise the
tone.
SET VOLUME LEVEL
<        >
Volume Level
Set the keypad internal speaker volume level for key presses and entry delay tone
conditions. During alarm and trouble conditions, the volume is always at maximum
level. Use the left Select key to decrease the keypad volume and the right Select key
to increase the volume. Press the COMMAND key to display the Model Number.
MODEL NUMBER
V200 071603
Model Number
The LCD displays the keypad firmware version and date. The user cannot change this
information in User Options.
KEYPAD ADDRESS
01
Keypad Address
The LCD displays the keypad address. While in User Options, the user cannot change
the keypad address. Press the Back Arrow key to exit the User Options function.
Keypad Options and Diagnostics
The keypad also contains Options and Diagnostic options that allow you to configure and test keypad operation.
You can only access Keypad Options and Diagnostics through the User Options. After holding down the Back
Arrow and COMMAND keys for two seconds to display SET BRIGHTNESS, enter the code 3577 (INST) and press the
COMMAND key. The display changes to KPD OPT (keypad options) KPD DIAG (keypad diagnostics) and STOP.