Pilz PIT m3.2p machine tools pictogram - Manual (Page 48)

Operation
Operating Manual PIT m3.2p
1003176­EN­02 48
7.1 Select operating modes OM1 ... BA4
Prerequisites
} A transponder key with the relevant authorisations must be present.
} The operating mode selector switch must recognise the transponder key as valid.
} The transponder key must be present at the operating mode selector switch for the
whole time the button is operated.
} Several buttons may not be operated simultaneously when selecting an operating
mode.
Procedure
1. Establish the connection with the transponder key
a Insert the transponder key into the slot.
Note: The transponder key must support the operating mode/operating modes into
which you wish to switch. The authorisation display LEDs provide information about
the authorisations available with the relevant transponder key (see
Control ele­
ments [ 10] ).
2. Select operating mode
a Select the required operating mode by pressing the relevant button.
Please note the required operating time (see Monitoring of operating time [ 50]
). The operating mode has been selected correctly if the button is rear lit once it is
released.
3. Complete operating mode selection
a Complete the operating mode selection by removing the transponder key.
Once you have removed the transponder key, the operating mode selector switch
behaves in accordance with the configuration (see
Switch behaviour after a
transponder key is removed [ 25] ).
INFORMATION
You can switch at will between the individual operating modes OM1, OM2,
OM3 and OM4; i.e. it is possible to switch from OM1 to OM3 or from OM4 to
OM2, for example.