6 wiring, 1 general wiring guidelines, 1 mechanical connection of the base modules – Pilz PSSu E S PD-D User Manual
Page 19: Section 6, Wiring, General wiring guidelines, Mechanical connection of the base modules, Din 5264-a
Wiring
Operating Manual PSSu E S PD-D
21975-EN-04
19
Wiring
General wiring guidelines
Please note:
}
Use copper wiring.
}
The terminal configuration as stated on the front plate applies for base modules with
C-rail. The terminal configuration as stated in the technical documentation applies for all
other base modules.
Mechanical connection of the base modules
Procedure:
}
Use a flat blade screwdriver (DIN 5264-A)!
DIN 5264-A
}
Strip the wire back 8 mm.
}
If necessary, label the connection level with a colour marker [3].
}
Base module with screw terminals:
– Use a screwdriver to loosen the screw on the screw terminal [1]
– Insert the stripped cable into the round fixing hole [2], as far as it will go.
– Tighten up the screw on the screw terminal.
– Check that the cable is firmly seated.
}
Base module with cage clamp terminals:
– Insert the screwdriver [4] into the square hole [1].
– Insert the stripped cable into the round fixing hole [2], as far as it will go [5].
– Pull out the screwdriver [6].
– Check that the cable is firmly seated.
6
6.1
6.1.1