StorCase Technology InfoStation 16-Bay 3U SCSI/SATA - Manual (Page 53)

40 RAID Controller Configuration
StorCase Technology, Inc. InfoStation 16-Bay RAID User's Guide - Rev. F00
RAID Configuration via HyperTerminal
NOTES: Microsoft ® Windows ® 3.x and Windows ® NT™ 3.5x include a program called
Terminal which does not support ANSI color. If using either O/S, select VT-100
for terminal emulation or use a third-party software program such as Procomm
for Windows.
Microsoft ® Windows ® 95/98/NT/2000 includes a program called HyperTerminal
that supports ANSI color.
Macintosh O/S includes a program called ZTerm for terminal emulation.
The Monitor Utility (HyperTerminal) may be used to configure the InfoStation RAID controller.
HyperTerminal Connection
To find HyperTerminal in Windows:
1. Click on Start (normally located at the bottom left of the Windows desktop)
2. Go to Programs
3. Go to Accessories
4. Go to HyperTerminal
Settings
(Figure 20A)
· Select the appropriate COM port that the StorCase serial cable is connected to on the host
(default = COM1).
· Set Bits Per Second to 115200.
· Set Data Bits to 8.
· Set Parity to None.
· Set Stop Bits to 1.
· Set Flow Control to None.