StorCase Technology DS570 - Manual (Page 21)

12 Installation
StorCase Technology, Inc. DS560/DS570 User's Guide - Rev. A04
INSTALLATION
CAUTION: The DS560/DS570 chassis contains NO USER SERVICEABLE parts inside
the unit. Refer ALL servicing to qualified personnel!
NOTE: Refer to the Data Silo DS550 User's Guide, Data Express DE90i-A100
or DE110 User's Guide for additional operating and installation informa-
tion. Also refer to the disk manufacturer's documentation for specific
information regarding the disks.
Drive Preparation
1. Remove the drive from its protective packaging.
2. Plastic Drive Bezel: If the drive came equipped with a plastic front bezel, it
must be removed before installing the drive into the drive carrier.
3. Master/Slave Drive Selection:
DS560 only - In most cases, your drive will be factory-configured as a Master
Ultra ATA/100 drive using a jumper plug on the drive itself. No
configuration changes are required.
DS570 only - In most cases, your drive will be factory-configured as a Master
Drive using a jumper option on the drive itself. StorCase
however, recommends reconfiguring the drive to Cable Select
instead. This can be done by configuring the jumper option on
the drive itself (refer to the drive manufacturer's documentation
for further information).
NOTE: Since specifications (specifically, pin assignments) between drive
manufacturers may vary, please refer to your drive manufacturer's
documentation for exact information regarding Cable Select configuration.