EXFO FVA-3150 Variable Attenuator - Manual (Page 24)

Setting Up Your Variable Attenuator
18 FVA-3150
Managing the Wavelength Shortlist
To add a wavelength to the shortlist:
1. Press the Setup button.
2. Use the left/right arrows to move until LAMBDA is displayed.
3. Use the up/down arrows to move until Add is displayed .
4. Press ENTER. A wavelength will be suggested and the first digit will
flash.
5. Use the up/down arrows to change the flashing digit and the left/right
arrows to activate the next digit.
6. Once all digits are set, press ENTER.
7. To exit the Setup menu, press the Setup button.
Note: If you are trying to enter a wavelength that is outside the wavelength range,
the Variable Attenuator will beep and reject the wavelength.
nm