EXFO FLS-2200 Broadband Source - Manual (Page 29)

Setting Up Your Broadband Source
Broadband Source 21
Reverting the Broadband Source to Default Settings
Reverting the Broadband Source to Default
Settings
You may want to revert the Broadband Source to the factory settings.
The following table presents the parameters and their default values.
To revert the source to default settings:
1. Turn off the unit.
2. Turn on the unit and press ENTER at the same time until the unit beeps
three times.
Parameters Default Values
Source OFF
Drive current Minimum value
Backlight ON
Videomode STD (standard)
Refresh rate 4 Hz
RS232/GPIB (Remote control)
a
a. Parameter cannot be reset by a remote control command.
GPIB
GPIB address
a
12
Baud rate
a
N.A.
Flow ctrl
a
N.A.