EXFO FLS-2200 Broadband Source - Manual (Page 119)

Broadband Source 111
C IEEE 488.2 and Specific
Command Reference
This chapter presents detailed information about the commands and
queries supplied with your FLS-2200 Broadband Source.
IEEE 488.2 Commands—Quick Reference
The Broadband Source recognizes the required commands identified in
IEEE 488.2. The table below summarizes these commands.
Command Function
*CLS Clear status command
*ESE Standard event status enable command
*ESE? Standard event status enable query
*ESR? Standard event status register query
*IDN? Identification query
*LOK
a
a. This command can only be used with RS-232 communication.
Set Remote Lockout programming state
*LOK?
a
Remote Lockout programming state query
*OPC Operation complete command
*OPC? Operation complete query
*REM
a
Set Remote programming state
*RST Reset command
*SRE Service request enable command
*SRE? Service request enable query
*STB? Read status byte query
*TST? Self-test query
*WAI Wait for pending operations to be completed