EXFO MaxTester DSL - Manual (Page 8)

Introducing the MaxTester DSL Test Set 2
Keypad
³
Power: The button on the lower left side of the unit is used to power the unit on
and off.
³
Arrow Keys navigate the screen to access and modify parameters.
³
Function Keys activate the corresponding on-screen function button.
Battery
The MaxTester DSL is equipped with a Lithium-ion battery.
When fully charged, the battery should provide between 3 and 10 hours of power
depending on different factors such as: type of tests performed, display backlight
level, and connected accessories.
To maximize battery power of the MaxTester DSL:
1. Lower the display backlight level using the application found in Display and
Language in the System settings, when the MaxTester DSL is used under low to
medium light conditions.
2. Disconnect any unused USB or SD accessories.
3. Quit any running tests when the MaxTester is not in use.
4. Whenever possible, put the MaxTester DSL in suspend mode by pressing for
less than 1 second,
5. When not in use, turn the unit off by pressing for at least 4 seconds.
W
ARNING
³
Recharge the battery using only the MaxTester and with the
battery properly installed in the unit.
³
Never open the battery back panel of the MaxTester without
reading the Replacing the Battery section in this chapter.
Function keys
Home/Help
Stop/Start test
Power
Back
Arrow keys
Enter