EXFO MaxTester DSL - Manual (Page 26)

Configuring the MaxTester DSL Test Set 20
³
DHCP Server enables the dynamic host configuration protocol (DHCP) mode
for the LAN side of the connection.
³
Platform Ip Address displays the IP address of the unit’s platform when the
DHCP Server is disabled.
To configure LAN setup values:
1. Press the up/down arrows to select the desired parameter.
2. Press the left/right arrow keys to view and select the options.
3. If you make any changes to the parameter values, press the on-screen function
keys to save or cancel your input.
Select Tests
The Select Tests page allows you to Enable/Disable the
following optional sub-tests, within the 3 types of test
applications.
³
IPTV Test - when enabled, all other sub-tests are
automatically disabled.
³
Ping is also known as ICMP echo request and
determines network connectivity and accessibility.
³
FTP test verifies the file transfer speed of the file
download and upload.
³
Traceroute is a complement tool of the Ping test to
determine why a destination cannot be reached, or
where the internet is broken.
³
Web Browser Test can only be started when a WAN
connection (either through xDSL or Ethernet) has
been established.
When enabled, the sub-tests’ test pages are available in the results pages.
When highlighted, the sub-tests’ setup contents are shown on the Test Setup tab.
Note: Select Tests and Test Setup tabs are not available in Sync Only and
Bridged Access Modes.
To select sub-tests:
1. Press the up/down arrows to highlight the desired test.
2. Press the left/right arrow keys to toggle between Enable/Disable.
OR
3. Press on any value to open the list box to toggle between Enable/Disable.