Auto iptv test setup – EXFO MaxTester DSL User Manual
Page 29
![background image](/manuals/736468/29/background.png)
MaxTester DSL
23
Auto IPTV Test Setup
The Auto IPTV Test Setup page in the IPTV test setup
allows you to define 2 types of IPTV tests to run
automatically:
³
IPTV Channel Analysis - Enable to add channels for
analysis. If disabled, channel analysis in auto test is
not performed.
³
Stream Time defines the length of time, from 1 to
60 s, to keep the channel stream(s) for analysis.
³
Channel 1-5 allows you to define up to 5 IPTV
channels for concurrent analysis.
³
Join/leave Test - Enable to define a list of channels to
sequentially join and leave. If disabled, no test is
performed.
³
Channel 1-10 allows you to define a list of up to
10 channels.
³
On-screen function buttons:
³
Add/Insert is available only when a blank entry is highlighted. When the
button is pressed, the first available channel from the alias Channel List is
automatically added to this list of channels. Upon highlighting another blank
entry, the next channel from the alias table is added, and so on.
³
Delete removes the selected channel from the list.
You can Enable either one or both, but you cannot Disable both of them at same
time. If both tests are enabled, Join/leave Test runs first.
To configure test setup values:
1. Press the up/down arrow keys to select the desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press
on a value to open a list box of options or the alphanumeric editor
screen and use the navigation keys to scroll through.
4. Press
to confirm the value.