EXFO MaxTester DSL - Manual (Page 31)

MaxTester DSL 25
To configure test setup values:
1. Press the up/down arrow keys to select the desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options or the alphanumeric editor
screen and use the navigation keys to scroll through.
4. Press to confirm the value.
5. If you make any changes to the parameter values, press the on-screen function
keys to save or cancel your input.
Traceroute Test Setup
The Traceroute Test Setup tab allows you the configure
the following parameters:
³
Address Format is URL or IP Address.
³
Destination Address is the destination IP or URL
address.
³
Max Hops specifies the maximum number of hops
(1 to 32) used in attempting to reach the destination
address.
³
Timeout is the time in seconds from 1 to 10, that the
unit will wait for a response back from the destination
device.
To configure test setup values:
1. Press the up/down arrow keys to select the desired
parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options or the alphanumeric editor
screen and use the navigation keys to scroll through.
4. Press to confirm the value.
5. If you make any changes to the parameter values, press the on-screen function
keys to save or cancel your input.