EXFO MaxTester DSL - Manual (Page 30)

Configuring the MaxTester DSL Test Set 24
Ping Test Setup
The Test Setup tab is available only if Access Mode is not
Sync only.
³
Address Format is URL, IP Address or Gateway.
³
URL/IP Address lists either the URL or IP Address
where the unit pings.
³
Packet Size is a value from 32 through 1200 of the
number of bytes sent in one packet. The default value
is 32.
³
Total Pings is the total number of Ping packets to
send out from1 through 99. The default value is 3.
³
Timeout is the time in seconds from 1 through 10, that
the unit will wait for a response back from the
destination device.
To configure test setup values:
1. Press the up/down arrow keys to select the desired parameter.
2. Press the left/right arrow keys to view and select the options.
OR
3. Press on a value to open a list box of options or the alphanumeric editor
screen and use the navigation keys to scroll through.
4. Press to confirm the value.
5. If you make any changes to the parameter values, press the on-screen function
keys to save or cancel your input.
FTP Test Setup
The FTP test verifies the file transfer speed of the file
download and upload. The FTP Test Setup tab allows you
to configure the following parameters:
³
Address Format is URL or IP Address.
³
FTP Server Address lists either the URL or IP
Address.
³
Login Name/Password is your user ID and password.
³
Download File Name is the filename requested for
downloading, maximum 128 characters.
³
Upload File Name is the filename used for uploading,
maximum 128 characters.
³
Upload File Size (kB) is the number of bytes or size
of the file to be uploaded to the server.
³
File Upload/Download - Enable/Disable options
available only in Auto Test Setup. Enable to perform the upload/download
operation automatically.