Eurocom D900K F-Bomb - Manual (Page 122)

Modules
7 - 22 RAID Setup
7
RAID Mode Setup
1. Install two identical serial hard disk drives
2. Prepare a formatted blank 3.5" 1.44MB floppy diskette, and an external USB
floppy disk drive.
3. Create a RAID Driver Diskette by using an operable computer to copy the
drvdisk folder from the Device Drivers & Utilities + User’s Manual CD-
ROM (Navigate/Browse.. to D:Drivers\Raid\drvdisk) to the blank floppy
diskette.
4. Startup your computer and press <F2> to enter the BIOS (see “Advanced
Menu” on page 5 - 8 ).
5. Go to the Advanced Chipset Control menu and set the “SATA RAID
Enable:" item to Enabled.
PhoenixBIOS Setup Utility
Advanced
F1 Help Select Item -/+ Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Advanced
Advanced Chipset Control
SATA RAID Enable [ Enabled ]
CPU FAN Speed: [Auto]
Card Reader: [Enabled]
Display Time on LED [Enabled]
Enable SATA RAID
function
Figure 7 - 8
Advanced Menu >
Advanced Chipset
Control (BIOS)