Delta RMC151 - Manual (Page 38)

RMC150 Startup Guide
Resolver Module Transducer Wiring
The wiring diagram below is for resolvers that fall within the Resolver
module’s signal specifications (800 Hz to 5 kHz and 1.41 to 4.8 VRMS).
The Ref In input is only used for reference signals outside of these
specifications, and requires contacting Delta for assistance.
8-pin Resolver
Connector
Ref Winding +
Ref Winding -
Sin Winding -
Cos Winding +
R1
Ref In
R3
S1
S3
S4
Cos Winding -
Sin Winding +
S2
Case
Pin Function
R1 Reference Output +
Ref In Reference In (normally not used)
R3 Reference Output -
S1 Sine Input +
S3 Sine Input -
S2 Cosine Input +
S4 Cosine Input -
Case Controller Chassis Ground (shield)
36 Delta Computer Systems, Inc.