Delta RMC151 - Manual (Page 18)

RMC150 Startup Guide
Start/Stop or PWM (Magnetostrictive) Feedback
1. In the Axis Parameters, on
the Setup tab, set the MDT
Type register to the type of
magnetostrictive transducer
you have.
This information is available
from your transducer
datasheet.
2. Click the Download button to apply the changes to the RMC.
3. Continue to the Verify Feedback section on page 18.
SSI Feedback
1. In the Axis Parameters pane,
on the Setup tab, set the
following cells.
• SSI Format
• SSI Data bits (e.g. 24)
• Linear/Rotary
This information is available
from your SSI device data
sheet.
Note: For help on a parameter, click the cell and press F1.
2. Click the Download button to apply the changes to the RMC.
3. Continue to the Verify Feedback section on page 18.
16 Delta Computer Systems, Inc.