Delta RMC151 - Manual (Page 20)

RMC150 Startup Guide
Verify Feedback
1. In the Axis Status Registers
pane, on the All tab, expand the
Feedback section.
For secondary inputs, expand the
Pressure/Force/Accel Feedback
section.
2. Look at the Counts register (for analog feedback, look at Volts or
Current).
It may be changing slightly.
3. Use the Direct Output command to move the axis back and forth
(as described in the Testing an Actuator section).
4. As the axis moves, look for a corresponding change in the Counts,
Volts or Current. If it does not change smoothly, recheck the
wiring, verify that the parameters on the Setup tab are correct,
and check for smoothly changing Counts, Volts or Current again.
5. Save the project and update Flash.
18 Delta Computer Systems, Inc.