Bonaire Touchpad - Manual (Page 20)

M ULTI -A PPLIANCE T OUCH P AD
Ducted Gas Central Heating
C LOCK S ETUP
Timer setup will take you through the steps to set your 12-hour clock. You
can use FINISH at any stage of setting the Day and Time.
Step 1 To select the CLOCK setup touch anywhere in the SETUP
outline.
Step 2 Press CLOCK. The 3 icons will disappear and edit mode has
begun.
Step 3 Three new icons will now be displayed ENTER, CANCEL &
FINISH.
•
•
•
Time s p is now complete and all functions are resumed.
S
Step 2 int OFF and turn the gas tap OFF. These connections are usually located
close to the Heater.
F
Step 1 n the power point to the heater. Turn on the gas tap on the gas supply line into the
Step 4 E. If the set
temperature is greater than the room temperature, the heater will resume operation.
ENTER will save each step of the program
CANCEL will abort the setup and no entries will be saved.
FINISH allows you to stop at any time and save the settings.
Step 4 Adjust the hours using the arrows. Press
ENTER
Step 5 Adjust the minutes using the arrows. Press
ENTER.
Step 6 Adjust the day using the arrows. Press
ENTER
etu
UMMER S HUTDOWN (O PTIONAL )
Step 1 Switch the Touch Pad OFF
Switch the power po
IRST S TARTUP O R R ESTART A FTER S HUTDOWN
Switch o
heater.
Step 2 Switch the Touch Pad ON.
Step 3 Select
HEAT in the Appliance area if not already displayed.
Press the arrows to increase or decrease the SET TEMPERATUR
Bonaire Control System
Page 20