Bonaire Touchpad - Manual (Page 13)

M ULTI -A PPLIANCE T OUCH P AD
Ducted Gas Central Heating
Congratulations on purchasing this ducted gas central heating system, an exciting new product
manufactured by Climate Technologies.
Wholly designed and manufactured in Australia, this Ducted Gas Central Heater represents an exciting
new development in warm air furnace design. It embodies the latest advances in gas heating technology.
Your heater is supported by Climate Technologies, Australia’s most advanced manufacturer of a
complete range of climate control products.
To ensure you fully enjoy the benefits of this Ducted Gas Central Heater, please read these instructions
carefully and keep them handy for future reference.
Operated and maintained in accordance with this manual, this unit will provide you with years of warm
and environmentally friendly operation. Please take the time to read this manual.
NOTE: The manufacturer and its service providers reserve the right to refuse service unless
safety and accessibility to the unit can be guaranteed in accordance with the installation
instructions and Australian Standards. The cost of any extra equipment required to provide
access to the unit for servicing is the responsibility of the owner.
General Information
I MPORTANT N OTICE
A licensed person is required to install Climate Technologies equipment. If the equipment is not installed
in accordance with the installation instructions and the governing body regulations, Climate Technologies
reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the electrical and
plumbing connections certifying that the work complies with all the relevant standards.
Note: Only a licensed person will have insurance protecting their workmanship.
D ATA L OCATION
Your appliance model number, serial number and model description are located on the appliance data
plate on the end of the heater or under the lid in the vicinity of the electronic controls. These details
should also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.
A SSEMBLY
There is no assembly required of this Ducted Gas Central Heater. Your Dealer or installer will carry out
all assembly and commissioning upon installation.
Bonaire Control System
Page 13