Dialogue Tech NANO-PV-D510A - Manual (Page 64)

NANO-PV-D510A User Manual
Page 50
4.6.1 AT/ATX Power Connection
Follow the instructions below to connect the NANO-PV-D510A to an AT or ATX power
supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the NANO-PV-D510A.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 3.
Step 2: Connect the Power Cable to the Motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the AT/ATX power connector on the motherboard.
See Figure 4-11.
Figure 4-11: Power Cable to Motherboard Connection