Dialogue Tech NANO-PV-D510A - Manual (Page 56)

NANO-PV-D510A User Manual
Page 42
Step 4: Insert into the socket at and angle. Line up the notch on the card with the
notch on the connector. Slide the PCIe Mini card into the socket at an angle of
about 20º.
Step 5: Push down until the card clips into place. Push the other end of the card
down until it clips into place on the plastic connector. Step 0:
4.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.