B.2.5 create factory default image – Dialogue Tech NANO-PV-D510A User Manual

Page 139

NANO-PV-D510A User Manual

Page 125

Step 6:

After completing the system configuration, press any key in the following window

to reboot the system.

Figure B-6: Press any key to continue

Step 7:

Eject the recovery CD.

B.2.5 Create Factory Default Image

NOTE:

Before creating the factory default image, please configure the system

to a factory default environment, including driver and application

installations.

To create a factory default image, please follow the steps below.

Step 1:

Turn on the system. When the following screen displays (Figure B-7), press the

<F3> key to access the recovery tool. The message will display for 10 seconds,

please press F3 before the system boots into the operating system.

Figure B-7: Press F3 to Boot into Recovery Mode

Step 2:

The recovery tool menu appears. Type <4> and press <Enter>. (Figure B-8)