D-Link DFE-2600 User Manual

Page 82

Text mode
Original mode

Dual-Speed Stackable Hubs User’s Guide

Master Hub Setup and Management

(including TCP/IP parameters, SNMP parameters, the enabled/disabled set-
tings of ports, etc.) will be erased and restored to their factory default
settings.

Choose Factory Reset NVRAM to Default Value from the main
menu. A confirmation message similar to that for the System Reset
will appear.

Move the cursor to Yes to confirm the reset and press

After a few seconds delay, the hub should restart, and all of its
parameters will revert to their default values.

Note:

Doing a factory reset to the Primary Master al-
so resets the Backup Master variables except
for the the Backup Master IP address.