D-Link DFE-2600 - Manual (Page 72)

Dual-Speed Stackable Hubs User’s Guide
Master Hub Setup and Management 60
♦
Port Speed. This field displays the port current operating speed
(100M or 10M) relative to the speed of the device connected to it.
♦
Speed Capability. This field displays the port current speed set-
ting, Auto for auto-detect/correct, 100M for 100Mbps connections
only, or 10M for 10Mbps connections only. This variable is user con-
figurable.
DFE-2600 Stackable Hub - Network Monitoring : Port State Menu
Group ID(1-8) [1] Port ID(1-24) [1 ]
Connector Type: UTP
Port Status Port State
Link Test: Up Link Test State:
Receive Polarity: Normal
Auto Partition:
On Admin State:
Port Speed: 100M Speed Capability: >
PREV GROUP NEXT GROUP PREV PORT NEXT PORT HELP SAVE EXIT
You can use PREV GROUP and NEXT GROUP to switch to another hub,
or PREV PORT and NEXT PORT to switch to another port. You can also
enter the port
Group ID and Port ID numbers to go directly to a different
port.
Monitoring the Hub Stack
The hub supports several monitoring functions, allowing you to keep statis-
tics on the operation of each port, each hub, and the entire network segment,
as well as to monitor the addresses of the packets received at each port.