D-Link DFE-2600 - Manual (Page 61)

Master Hub Setup and Management 49
♦
Boot Server IP Address. This variable is the IP address of the TFTP
server where the configuration file is located. This entry is used only if
the S/W Update Control is enabled and your boot protocol is TFTP
only; if you are using BOOTP&TFTP mode, or if Send BOOTP Re-
quest on Power Up is enabled, the address will be obtained from the
BOOTP server.
♦
Boot File Name. The pathname of the configuration file on your
TFTP server. If you are using D-View as your TFTP server, this is
the pathname of the .CFG file on your hard disk. This entry is used
only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if Use BOOTP to get IP after start up is en-
abled, the pathname will be obtained from the BOOTP server. For
more information about the DFE-2600 series master hub configuration
file, see Appendix C, Boot Configuration File.
DFE-2600 Stackable Hub - Software Update Menu
Software Update
Software Update Mode >
Boot Protocol
Boot Server IP Address [210.68.85.36 ]
Boot File Name [c:\dfe2600i.cfg ]
Last Boot Server IP Address: 210.68.85.35
HELP SAVE EXIT
SNMP Information
The System Configuration Menu screen shows a variety of information about
your hub, and allows you to set the System Name, System Location, and
System Contact. These settings can be retrieved from the hub using SNMP