D-Link DFE-2600 - Manual (Page 129)

Boot Configuration File 117
♦
auth-trap enable/disable
Enables or disables authentication failure traps for invalid SNMP com-
munity names. The argument for this field is either
enable or
disable .
♦
clear-SNMP-comm-table
Clears the hub SNMP community name table.
♦
SNMP-community community permissions
Adds a community to the hub list of SNMP communities, with access
permissions. Four entries is the maximum allowed. The community
name can be up to 32 characters long. Permissions can be read for read-
only community access, or write for read-write community access.
♦
clear-ip-trap-manager-table
Deletes all entries from the hub trap manager list.
♦
ip-trap-manager address community
Adds the host at address to the hub SNMP trap manager list. Four
entries is the maximum allowed. Traps sent to the host will use the com-
munity name variable
community , which may be up to 32 characters
long.
♦
telnet-idle-time n
Sets the hub maximum allowed console interface idle time to n
minutes.
♦
node-age-time n