D-Link DFE-2600 - Manual (Page 80)

Dual-Speed Stackable Hubs User’s Guide
Master Hub Setup and Management 68
DFE-2600 Stackable Hub - Network Monitoring : Bridge Information
Hub ID Bridge Present Bridge Status
1 Bridge Enable
2 N/A Disable
3 N/A Disable
5 N/A Disable
EXIT
Resetting the Hub
You can use the console program to reset the hub stack, either doing a system
reset (which restarts the hubs and is identical to powering them off and back
on again) or a factory reset (which resets the master hub, reverts all of its
parameters back to their factory default values, and restarts the entire hub
stack).
Important Note: If it is necessary for you to power-off
the hub (or hub stack) and then re-
start it instead of using the reset
functions, the hub MUST BE
POWERED-OFF for a MINIMUM of
TEN SECONDS.