D-Link DFE-2600 - Manual (Page 21)

Unpacking and Setup 9
Rear Panel
(Note that the figure shows the rear panel for master models.)
♦
Module Slots
Used to install module options for various kinds of additional connec-
tions, as well as the DFE-260S 10Mbps/100Mbps bridge module. (In the
DFE-2616x, DFE-2616ix, DFE-2624x and DFE-2624ix, module slot 1 is
already occupied by the switch module which is standard on these mod-
els.)
♦
Daisy-Chain IN Port
When cascading a set of D-Link stackable dual-speed hubs, this port
should be connected to the Daisy-Chain OUT port of the previous hub in
the stack (usually placed immediately above it). A cascade of five hubs
can be created in this way. The first and last hubs in the stack use only
one of the daisy-chain ports, while the others use both.
♦
Daisy-Chain OUT Port
Works in conjunction with the Daisy-Chain IN Port (see above). Connect
this port to the Daisy-Chain IN Port of the next hub in the stack (usually
placed immediately below it), using the enclosed daisy-chain cable.
♦
Diagnostic (Console) Port -- Master Models Only