D-Link DFE-2600 - Manual (Page 128)

Dual-Speed Stackable Hub Web-based Management User’s Guide
Boot Configuration File 116
Takes string as the System Contact, corresponding to the SNMP MIB-
II object sysContact. This field is used to give the name and contact in-
formation of the person responsible for the hub. The
string can be up
to 64 characters long.
♦
syslocation string
Takes string as the System Location, corresponding to the SNMP
MIB-II object sysLocation. This field is used to indicate the physical lo-
cation of the hub for administrative purposes. The
string can be up to
64 characters long.
♦
baud-rate n
Sets the serial port communication rate used when the port is being used
in out-of-band mode. Legal values for the parameter
n are: 2400, 4800,
9600, and 19200.
♦
2600h-image string
Takes string (which may be up to 64 characters long) as the filename
of the image file to be downloaded from the TFTP server. When the hub
boots, it will load the given image file from the server and execute it.
This command may be used to update the hub
software when a new
version is available from D-Link.
♦
ip-netmask mask
Uses mask as the network mask for the local network. For a Class C
network with no subnetting, the netmask should be 255.255.255.0.
♦
ip-default address
Uses address as the hub default gateway address. The address
should be in the form xxx.xxx.xxx.xxx, where each xxx is a number be-
tween 0 and 255.