D-Link DFE-2600 User Manual
Page 38
Dual-Speed Stackable Hubs User’s Guide
Making Connections
26
connections require either a Category 5 UTP cable or an STP cable. These
cables can be up to 100 meters long.
Each Ethernet connection requires a Category 3 or better UTP cable and can
also be up to 100 meters long. It is recommended that you use Category 5
cabling for all connections, in order to make it easier to transition all stations
to 100Mbps.
You can connect any combination of PCs, servers, and other single-address
network devices to the twisted-pair ports using straight-through twisted-pair
cables. These cables should not be crossed over. The following figure illus-
trates the pin assignments for a straight-through cable:
When connecting a PC or a server, the system being connected should have
an Ethernet or Fast Ethernet network interface card with a twisted-pair port.
The following figure shows a typical connection between the hub and end-
stations: