Ask Proxima DP5600 - Manual (Page 41)

c
LAMP REPLACEMENT
If the lamp fails to come on and the lamp monitor on the projector light is orange, you must replace the bulb.
A * For continued safety, replace with a lamp assembly of the same type.
• Allow the projector to cool for at least 45 minutes before you open the lamp cover. The
inside of the projector can become very hot.
• Do not drop the lamp module or touch the glass bulb ! The glass can shatter and cause
injury.
• To prevent operator injury, the lamp cover is locked. Unless the guard is in the unlocked
position, the lamp cover will not disconnect even if the screws have been removed.
Follow these steps to replace the lamp assembly.
1. Turn off the projector and allow the projector to cool thoroughly.
2. Disconnect the AC cord from the projector and slide the guard to the unlock
position.
3. Remove 2 screws with a screwdriver and disconnect the lamp cover.
4. Remove 2 screws with a screwdriver and pull out the lamp assembly by
grasping the handle.
5. Replace the lamp assembly.
6. Tighten 4 screws to secure the lamp cover to the lamp assembly.
7. Slide the guard, locking the lamp cover.
8. Connect the detachable AC cord to the projector.
:)
LAMP REPLACEMENT
INDICATOR
9. Reset the lamp replacement monitor timer.
(1) . Plug the projector into an AC outlet and switch the power on.
(2) . Wait for about 30 seconds until the wait display goes off.
(3) . Press the Reset switch on the left side of the projector using the tip of a
bail-point pen for two seconds.
(4) . ’’RESET” will appear on the screen and go off after a few seconds.
The timer is now reset.
NOTE: Do not press the RESET SWITCH, except after the lamp replacement.
RESET
SWITCH
RESET
, 41 _