Ntsc i pi-^' [7.w ■<»), Picture image adjustment fvideo mode) – Ask Proxima Ultralight LS1 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This projector is adjusted at the factory to produce suitable picture images. If you want to tune the pr
finely.
It
can be adjusted
at
IMAGE ADJUSTMENT.
1. Press MENU button and MAIN MENU DISPLAY dialog box will appear.
2. Press POINT LEFTiPlGHT button(s) to select IMAGE and press SELECT button. Another dialog box 1
ADJUST DISPLAY will appear. This shows the current picture settings.
3. In this dialog box. you can adjust the settings by increasing or decreasing the levels shown as number
itentt and the range of the levels that you can adjust are summarized in the table as below.
4. Press POINT DOWN button and a red arrow will appear.
5. Move the arrow to an item that you want to adjust by pressing P^NT UP/DOWN button(s).
6. To increase the level, point the arrow to
A
and then press SELECT button. To decrease the level, po
arrow to
T
and then press SELECT button.
7. You can store the settings in the memory to recall them later. To store the settings, move the arrow to'S
and then press SELECT button. When you have stored the settings. 'OK
T
is displayed for confinnation.
8. Move the arrow to Yes and then press SELECT button. The stored settings are permanently held e
POWER ON/OFP is switched off.
9. To quit Picture Image Adjustment Menu, move the arrow to Quit and then press SELECT button.
10. If you do not want to store the settings, move the arrow to Quit and then press SELECT button. The sc
changed remains effective until POWER ON/Of F switch is turned off.
11. To recall the settings from the memory that you have stored, move the arrow to Reset and then
SELECT button. When you have reset the settings. *OK ?* is displayed for confirmaton. Move the arr
Yes and then press SELECT button. You can adjust the settings again if needed.
NOTE: TINT* is slopped during in the PAL and SECAM mode.
PICTURE IMAGE ADJUSTMENT fVIDEO MODE)
MAIN MENU DISPLAY
ygj»—•-------
NTSC I
Pi-^' [7.W ■<»)
Eft?
IMAGE
ADJUST DISPLAY
• ^Color
1 32 1
®TTnt
rs"!
Э Contrast
^Brightness 1 32 1
A.-
^ -
OSharpness 1 1« !
c
Reset
)
■
)
C
Stored
)
c
Ouc
) ^
TABLE OF PICTURE IMAGE ADJUSTMENT
COLOR
DECREASES
0-^
63
INCREASES
TINT
MORE PURPLE
0 —
63
MORE GREEN
CONTRAST
UGHTER
0-^
63
DEEPER
BRIGHTNESS
DARKER
0-^
63
BRIGHTER
SHARPNESS
SOFTER
0-^
31
SHARPER
— Э0 —