Ask Proxima Ultralight LS1 - Manual (Page 12)

c
CONNECTING THE PROJECTOR
This projector has various kir)d of input/output terminals to connect with peri;
equipment. Connect the projector to the equipments before turning it on.
CONNECTING THE COMPUTER
CONNECTINQ TO THE COMPUTER INPUT HDB15-PIN fVGA) TERMINAL
A computer can be connected to the HOBtSpin terminal on the protector.
• Connect the computer to this terminal using the VGA cable and VGA/MAC adapter
(suppfied).
CONNECTING TO THE MONITOR OUTPUT HDB1S»PIN (VGA) TERMINAL
This terminal outputs only computer input signal to the monitor.
A monitor can be connected to the HDBlS-pin (VGA) terminal on the projector.
• Connect the monitor to this terminal using the monitor cable (not supplied).
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS
• Connect audio outputs from your computer to the jacks using №e audio cable.
CONNECTING TO THE MULTNPOLE 12»P1N (CONTROL PORn
Í
I If you wish to control the computer with projector's remote control unit, you must conrt
the control port (PS/2. Serial or ADB port) on your computer to the projector's control Pv. i
with one of the suppled cables, (three type cables provided: for PS/2 Port. Serial Port ane
A08 Port)
•1
^
0
t *-
/
CONTROL PORT CABLE REMOVAL HINT
Disconnect control port cable with foHowing steps. ^ 2
t. Hold the portion (A) of the connector with one hand.
2. Pull the portion (8) arrow direction and remove
r \
3 J ^
coooector. A Y
CONNECTING TO THE DIN 8 (SERIAL PORT) CONNECTOR
1.
I If you control the projector by computer, you must connect a cable from your computer to
this connector.
^ ri. j;;
tA 'S