Ask Proxima Ultralight LS1 - Manual (Page 27)

c
BASIC OPERATION
TURNING ON THE PR^JECTOR
1. Connect pofipheral equipment (Computer. VCR. and etc.) belore turning on the
projector. (Retef to *CONNeCTING THS PROJECTOR' on Pages 10-15 (or
connecting those equipments.)
2. Connect the AC power cord of the projector into a wall outleL Make sure READY
INDICATOR on TOP CONTROL turns to green, and LAMP INDICATOR turns to
red.
3. Press ON^F BUTTON on TOP CONTROL or REMOTE CONTROL LAMP
INDICATOR turns dim.
4. A number appears on the screen, and NUMBER counts down until picture image is
displayed. It’s takes about 30 seconds to project a image.
NOTE: Turn on the computer last when the computer is connected In system.
A
CAUTION
THIS PROJECTOR USES A UHP LAMP. TO MAINTAIN THE UFE OF LAMP. ONCE YOU TURN IT
ON. WAfT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.
NOTE:When TEMPERATURE WARNING INDICATOR flashes red. the protector will automaticaly turn off.
Wait at least 5 minutes to turn the projector on again.
If TEMPERATURE WARNING INDICATOR conbnues to flash, follow the procedures below:
1. Press POWER ON-OFF BUTTON to OFF.
2. Check if the air filter is contaminated with dust. The air filter must be maintained and cleaned.
Refer to ‘AIR FILTER CARE AND CLEANING* on Page 45.
3. Press POWER ON-OFF button to ON.
If TEMPERATURE WARNING INDICATOR stll consnues to flash, call your authorized dealer or service
station.
TURNING OFF THE PROJECTOR
1. Press the POWER ON-OFF button on TOP CONTROL or REMOTE
CONTROL The message ‘Power off?’ appears on the screen.
2. Press again POWER ON-OFF button to turn the projector off. Make sure
LAMP INDICATOR turns to bright. READY INDICATOR turns off and the
cooling fans operate for 1 minute for cooling the projector after switched off.
(NOTE : During the cooling sequence the projector, cannot be turned on.)
3. When coofing of the projector is finished. READY INDICATOR turns to green
again. You can turn the projector on again.
Power off ?
— 25 —