Ask Proxima DP5950 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
coi!ow these steps to clean the pivfecSon lens-
ipply a non-abrasfve camera lens cisan^r fn »
^
.
.. -Avoid using an excessive amount of
ciTnef ^
cteaning ciolh.
Abrasive cleaners,
solvents or other
hamh
,
2. LigMiy
wipe
the cleaning cloth over the Jens ”
scratch the Jens
- d o n l intend to
use
the ptqector immediately, repiaee
3. rt you ’
the lens cover.
ggfore caing your dealer or.sefvice station lor assistance, follow these steps, to make sure everything is properly
y°u have connected the projector to your equipment as described in section ” CONNECTING THE
PROJECTOR” on pages 10- 17.
Check
cable connections. Verity that all computer, video and power cords are property connected.
3
Verity that power is switched on.
4
If the projector stl does not display an image, restart the computer.
if iris image still does not display, unplug the projector from the computer and check the computer monitor's display.
^ Tne'probiem may be wîh your graphics controller rather than with the projector. (When you reconriect the projector,
remember to turn the computer and monitor off before you power up the projector. Power the equipment back up in
this order:
Projector, monitor, computers
5
}f
the problem still exists, check the following chart.
i
Problem:
No power
: TryîîHéiss Soïiîtiôns:
• Plug the projector into an AC outlet.
• Turn the MAIN ON/OFF button to OM.
• Press the LAIVIP POWER ON/OFF switch to ON.
• Be sure the READY INDICATOR light is ON.
• Wait one minute after the projector is turned OFF befo-'-e
turning the projector back on.
NOTE: After pressing the LAMP POWER ON/OFF button to
OFF . The projector functions as indicated.
1. The LAMP POWER indicator wit! fight and the READY
indicator will turn off.
2. After one minute, the READY indicator will light green again
and ih© projector may be turned on by pressing the LAMP
POWER ON/OFF button.
• Check temperature warning indicator, if the Indicator flashes
red. the projector cannot be turned on.
(See “USING THE PROJECTOR” section on page 27).
• Check the projection lamp.
image is out of focus
• Adjust the focus.
• Make sure the projeciion screen Is a! least 3.6 feet (1.1 m>
from the projector.
the projection tens to see if it .needs cioani.ng.
NOTE: Moving the projector from a cool temperature location
to a warm temperature location may result in moisture
condensation on the lens. In such an event, leave the
projector OFF and wait until condensation disappears.
■
49
-