Ask Proxima DP5950 - Manual (Page 37)

St picture adjustment have been preset at the factory. If you want to change the setting, operate the projector as
follows.
1 Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear.
2 Press the POINT LEFT/RIGHT BUTTON(s) to select IMAGE and press the SELECT BUTTON. Another dialog
3 r Pox IMAGE ADJUST DISPLAY will appear. This shows the current picture settings.
3
. in this dialog box, you can adjust the settings by increasing or decreasing ttie levels shown as numbers. The
' items and the range of the ieveis that you can adjust are summarized in the table below.
4
. Press the POINT DOWN BUTTON and a red arrow will appear.
5 * Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN BUTTON(s).
g' To increase the level, point the arrow to A and then press the SELECT BUTTON. To decrease the level, point
the arrow to V and then press the SELECT BUTTON.
7 You may want to store the settings in the memory so that you can recall them later. To store the settings, move
d ■ the arrow to Stored and then press the SELECT BUTTON. When you have stored the settings, ”OK T is
displayed for confirmation.
if g. Move the arrow to Yes and then press the SELECT BUTTON. The stored settings are permanently held even if
the MAIN ON/OFF is switched off.
g Jo quit the MENU, move the arrow to Quit and then press the SELECT BUTTON.
10^ If you do not want to store the settings, move the arrow to Quit and then press the SELECT BUTTON. The
settings changed remains effective until the MAIN ON/OFF switch is turned off.
1 1. To recaí! the settings from the memory that you have stored, move the arrow to Reset and then press the
3 SELECT BUTTON. When you have reset the settings, ”OK ?” is displayed for confirmation. Move the arrow to
Yes and then press the SELECT BUTTON. You can adjust the settings again if needed.
PICTURE IMAGE ADJUSTfUIENT (COMPUTER MODE)
MAIN MENU DISPLAY
■<»)
A?
English j/l
IMAGE ADJUST
DISPLAY
NOTE: The projector may not reproduce a
proper image for some XGA
signals.
Since XGA (1024 x 768) image is
converted to 800 x 600 image by
partial scan, some lines and dots
of the image do not appear.
Some video noise of flicker on this
compressed XGA image cannot
be eliminated even though you try
to make a Fine sync adjustment.
fi.Total dots
V j Whrte balana
-^^vRedlr
Greerjnrg^
^ Blue.
3 Contrast -
^ Brfqhtnessil 32
( Quit'
OK?
)t?fVYes'
No >
TABLE OF PICTURE IMAGE ADJUSTMENT
FINE SYNC Adjust the picture as necessary to eliminate _____________________ __
flicker from the display.
TOTAL DOTS The number of the total dots in one horizontal period. Adjust the
number to match your PC image.
WHITE BAfcANCE (R/G/B)
CONTRAST
I BRIGHTNESS
DECREASE 0 63 INCREASE
LIGHTER 0 63 DEEPER
DARKER 0 63 BRIGHTER
• 3 7 -