Lamp replacement – Ask Proxima DP5950 User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
c
LAMP REPLACEMENT
If the lamp fails to come on and the lamp monitor on the projector Ight is orange, you ¡musí replace the buib.
For
continued
safety, replace with a
lamp
assembly of
the
same type.
A
• Allow the projector to coof
for
at least 45 minutes
before
you open the lamp cover. The
inside
of
the projector
can
become
very
hot.
• Do not drop the lamp module or touch
the
glass bulb ! The glass can shatter and
cause
injury.
Follow these steps to replace the (amp assembly.
1
. Turn off the projector and allow the projector to cool thoroughly,
1
2. Disconnect the AC cord from the projector.
13. Remove screw with a screwdriver and disconnect the lamp cover.
4. Remove
2
screws with a screwdnver and pull out the lamp assembly by
grasping the handle.
5. Replace the lamp assembly.
6. Tighten 3 screws to secure the tamp cover to the lamp assembly.
7. Connect the detachable AC cord to the projector.
LAMP REPLACEMENT
INDICATOR
LAMP
8. Reset the lamp replacement monitor timer. (See "LAMP AGE" section on page 46.)
NOTE; Do not reset the LAMP REPLACEMENT MONITOR TIMER, except after the lamp is replaced.
-48
—