Ask Proxima DP5950 - Manual (Page 3)

c
IMPORTANT SAFETY INSTRUCTIONS
■ 'I the safety and operating instructions should be read
the product is operated.
Read all of the instructions given here and retain them for
later use. Unplug this projector from AC power supply
before cleaning. Do not use liquid or aerosol cleaners. Use
a damp doth for cleaning.
Do not use attachments not recommended by the
manufacturer as they may cause hazards.
Do not place this projector on an unstable cart, stand, or
table. The projector may fall, causing serious injury to a
child or adult, and serious damage to the projector. Use
only with a cart or stand recommended by the
manufacturer, or sold with the projector. Wall or shelf
mounting should follow the manufacturer’s irrstructions,
and should use a mounting kit approved by the
manufacturer.
Do not expose this unit to rain or use near water... for
example, in a wet basement, near a swimming pool, etc...
Siots and openings in the back and bottom of the cabmet
are provided for ventilation, to insure reliable operation of
the equipment and to protect it from overheating.
\openings should never be covered with cloth or other
■ , f ' a n d the bottom opening should not be blocked by
,the projector on a bed. sofa. rug. or other similar
surface. This projector should never be placed near or
ever a radiator or heat register.
This projector should not be placed in a built-in installation
such as a bookcase unless proper ventilation is provided.
This projector should be operated only from the type of
power source indicated on the marking label. If you are no*
sure of the type of power supplied, consult your authorized
dealer or local power company.
Do not overload wall outlets and extension cords as this
can result in fire or electric shock. Do not allow anything to
rest on the pov^er cord. Do not locate this projector where
the cord may be damaged by persons walking on it.
Never push objects of any kind into this projector through
cabinet slots as they may touch dangerous voltage points
or short out parts that could result in a fire or electric
snock. Never spill liquid of any kind on the projector.
Do not attempt to service this proiector yourself as opening
cr removing covers may expose you to dangerous voltage
or other hazards. Refer ail servicing to' qualified ser\'ice
p " ortnef.
D. projector from wall outlet and refer servicing to
qualified service personnel under the following conditions:
a. When the power cord or plug is damaged or frayed.
b. If liquid has been spilled into the projector,
c. If the projector has been exposed to rain or water.
d. if the projector does not operate normally by following
the operating instructions. Adjust only those controls
that are covered by the operating instruetjorrs as
improper adjustment of other controls may result in
damage and will often require extensive work by a
qualified technician to restore the projector to norma!
operation.
e. If the projector has been dropped or the cabinet has
been damaged. _
f. When Itie projector exhibits a distinct change inJ
performance-this indicates a need for service.
When replacement parts are required, be sure the service
technician has used replacement parts speciied by the
manufacturer that have the same characteristics as the
original part Unauthorized substitutions may result in fire,
electric shock, or injury to persons.
Upon completion of any service or repairs to ftiis projector,
ask the service technician to perform routine safety checks
to determine that the projector Is in safe operating
condition.
GROUND
Follow all
projectors. warnings
This projector is equipped with a
grounding type AC line plug.
Should you be unable to insert
the plug into the outlet, contact
your electrician. Do not defeat
the
safety purpose of this
grounding type plug,
and instructions marked on the
For added protection to the projector during a lightning
storm, or when it is left unattended and unused for tong
periods of time, unplug it from the wall outlet. This will
prevent damage due to lightning and powerline surges.
mw.
i
An appliance and cart combination
should be moved with care. Quick
stops, excessive force, and uneven
surfaces may cause the appliance
and cart combination to overturn.
If the projector is to be built into a compartment or similarly
enclosed, the minimum distances must be maintained.
Do not cover the ventilation slot on the projector.
Heat bulld-up cars reduce the service life of your projector,
and can also be dangerous. , ^
1 r
-
5
20 cm
PROJECTOR
(FRONT)
WAI
.So cm