Preparing to use centreware scanning services, Enabling the transport protocol (udp), Preparing to use centreware scanning services -12 – Xerox 423 User Manual
Page 22: Enabling the transport protocol (udp) -12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Preparing to use CentreWare Scanning Services
The following preparation is neoessary to soan a dooument by using
CentreWare Spanning Servioes:
> Define IP address (See “Defining the iP Address” on page 2-5)
> Enable transport protoool (UDP)
> Enable FTP Client
The prooedure forsetting up is as follows:
NOTE: When the setting for the maohine is oompleted, install the
CentreWare Soanning Servioes by referring to the CentreWare
Soanning Servioes User Guide.
Enabling the Transport Protocol (UDP)
To define the job template server using the Soan Admin Wizard of the
CentreWare Soanning Servioes, enable the transport protoool (UDP)
on the printeroontrol panel of the maohine.
Follow the prooedure below to enable the transport protoool (UDP).
Ready to print
or fax
©
Press
Menu
Quick Setup
©
Press
Menu
Network/Port
Press ^
^ I or Y I a few times until the following appears
Network/Port
Parallel
0 Press ^ or
3 few times until the following appears
.To next page
Page 2-12
XEROX WorkCentre Pro 423/428 Scanner User Guide
Menu