Enabling the salutation, Enabling the salutation -8 – Xerox 423 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Enabling the Salutation
Enable Salutation on the printeroontrol panel.
Ready to print
or fax
©
Press
NOTE: RAM for the printer is not installed, Salutation
oannot be enabled due to insuffioient memory. If this
happens, disable ports thatyou are not using. If the
Salutation still oannot be enabled, you are then
reoommended to install the 64MB SDRAM for the
printer. Please referto your User Guide (Printer).
Menu
Quick Setup
■ (2)
À
or
T
^ a few times until the following appears
Menu
Network/Port
(D Press ^
Network/Port
Parallel
(J) Press ^
a few times until the following appears
Network/Port
Salutation
Press ^
Salutation
Port Status
(D Press ^
I
Switch off/on the power
Port Status
Disable'
Ready to print
or fax
!
(2)
Press
Y
T
Press Clear All on the copier
control panel
Port Status
Enable
; (D Press
Ejecî/Seî
T
(g) Press
Port Status
Enable'
(When “Ready to print or Fax” appears, the
printer is ready to receive data.)
Page 2-8
XEROX WorkCentre Pro 423/428 Scanner User Guide
Menu
Menu