36" sno-thro, Installation, Safety first – Ariens 929000 User Manual
Page 80
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION
36" SNO-THRO
1. Place sno-thr-o mounting, pivots in the tractor
saddle brockets and secure with the latches and locks,
Figure 10.
2. Lower attachment lift lever and secure lift arm
to the lever with a hair pin cotter.
3. Attach lift assist springs as shown in Figures 6
and 10.
NOTE: The springs can be attached to the
sno-thro
frame
in
any
of
three
different
mounting
holes. The front hole provides maximum flotation and
easiest lifting of the sno-thro. The rear hole provides
FIGURE 11
the
least
flotation
and
may
be
desirable
in
hard-
packed
snow.
4,
Insert chute crank through the hole in the
chute crank support. Figure 6, and insert the opposite
end through the universal joint on the snow head.
Figure 10, and secure with
a
hair pin cotter.
5. Check belt to be sure it is still in position as
shown in Figure 11. Install belt onto sno-thro sheave.
Figure 9, on the tractor.
Fill our pre-warranty registration card and mail to
Ariens
Company.
INSTRUCT
THE
CUSTOMER
THOROUGHLY
ON
HOW TO OPERATE THE SNO-THRO. POINT OUT ALL
SAFETY
PRECAUTIONS
AS
SHOWN
IN
THE
OWNERS
MANUAL.
CAUTION
THE
CUSTOMER
TO
KEEP
ALL
GUARDS AND SHIELDS IN PLACE WHEN OPERATING
AND
TO
READ
THE
OWNERS
MANUAL
BEFORE
OPERATING THE UNIT.
SAFETY FIRST
IMPORTANT
A
BE A SAFE OPERATOR. Before attempting to
operate
the
sno-thro,
thoroughly
acquaint
yourself with:
1. The safety information in the
Owner's
Manual.
2.
The
operating
instructions
in
the
Owner's Manual.
3.
The
controls
on
the
tractor
and
sno-thro.
FIGURE 10
Unsafe operating practices and improper use of
the troctor and sno-thro on the part of the operator
can result in injuries. Observe the following safety
precautions at all times:
i
PAGE 80