Additional information about rolled hemming, Rosette – SINGER 14SH654 Finishing Touch (LED) User Manual
Page 74
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information About Rolled Hemming
• Hold the thread chain when you begin sewing to
keep it from curiing into the seam.
Piace a siight tension on the materiai in the sewing
direction and a finer seam finish can be obtained.
The minimum overedge stitch width that can be
obtained for rolled hemming is approximately
1.5mm (1/16 inch) since the cutting width cannot
be set below 3.5mm (9/64 inch).
To Secure the Rolled Hem Thread Chain
Apply a small drop of liquid seam sealant to the
end of the seam. Allow to dry, then cut the chain
close to the stitches.
Note: Test the liquid seam sealant for color
fastness before use.
Rosette:_______________________________
Set machine up for 3 - thread wrapped rolled hem
stitching, insert wire or fishing line between presser
foot & knife, finish one long edge of a 14"x2" piece of
fabric.remove wire or line from presser fbot.set
machine up for 3 - thread overlock (page 61).
Set differential feed to 2.0.
Sew (gather) other long edge of fabric.
Roll fabric into rosette & selure gathered dege.
73