Multi-stitch zig-zag bar tacks – SINGER 3150 User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Multi-Stitch Zig-Zag Bar
Tacks
With the multi-stitch zig-zag you can make
strong bar tacks. Multi-stitch zig-zag bar tacks
are effective for tacking belt loops on hedvy
fabrics such as denim. Be sure to check the
Fabric. Thread and Needle Table on page 16 for
correct thread and needle selection with your
choice of fabric.
•
Stitch: Multi-Stitch Zig-Zag Disc 2
•
Needle Position: L EU
• Stitch Width: : 111[1]
•
Stitch Length: 0 to 4.
•
Snap-in feed cover.
• General purpose foot or special purpose
foot.
We recommend making a test sample st using
scraps of the material you will be se\/ing the
bar tacks on duplicating all thicknesses.
1. Mark position for the finished end of belt
loop on the fabric.
•
Place belt loop, wrong side up, straight
stitch with cut end 3 mm (1/8 inch)
from edge of garment; do not stitch
beyond edges of the belt loop. Trim the
end close to the stitching and press.
2. Fold belt loop back on the stitching line and
press.
•
Set your machine according to the code
above.
•
Stitch 3 mm (1/8 inch) from the fold
using the multi-stitch zig-zag.
3. Fold over loose end and bar tack.
59