The bobbin thread, Winding the bobbin, Rthe bobbin thread – SINGER 3150 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Q
e
\JJ/
r
The Bobbin Thread
Winding the Bobbin
Preparation Steps
1. Raise the presser foot and turn hand wheel
toward
you
until
needle
is
in
highest
position.
2.
Loosen hand wheel knob A by turning it
toward
you
with
the
right hand
while
holding hand wheel with the left hand.
3. Place thread spool on spool pin with thread
retaining slit B to the right. (Break paper at
the end of spool if necessary).
•• Place spool holder C on spool pin and press
firmly against the thread spool.
Winding Steps
•
Snap thread into thread guide post D and
open top cover.
•
Lead thread around bobbin winder tension
disc E, as illustrated, and through small hole
in bobbin from inside out.
Place bobbin on spindle and move bobbin
winder F to right.
•
Hold thread end and start the machine. Cut
off thread end after a few coils have been
wound.
•
When required amount of thread has been
wound (winding will stop when bobbin is
full)
stop
machine
and
cut
connecting
thread.
•
Move bobbin winder to the left and remove
bobbin.
•
Hold hand wheel and tighten hand wheel
knob.
23
J