Buttons, Attaching a button, Boutons – SINGER 9614 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
0 V 2 • 4 • 6
Buttons
—wwV\/\
0 *
2 • 4 • 6
0 •
2 • 4 • 6
T « T f
• Pattern Selector: 1-2-3-4-5
,1—I
• Needle Position: j^i
• Stitch Width: To suit button
• Stitch Length: 0
• Snap-in Feed Cover
• General Purpose Foot
ATTACHING A BUTTON
Flat buttons can be sewn on by machine
using the zig-zag stitch.
• Insert Snap-in Feed Cover as instructed
on page 11.
1. Set stitch width selector at 0.
• Set needle position at left !m .
• Place button positioned on fabric under
foot and lower needle into centre of left
hole.
• Lower presser foot.
• Turn hand wheel toward you until the
needle rises out of button hole and is
just above the presser foot.
2. Set stitch width selector to a medium width
zig-zag setting.
• Continue turning hand wheel until the
needle is above right hole, adjust stitch
width, as necessary, until needle enters
the centre of the right hole.
• Take six or more zig-zag stitches and fin
ish with the needle on the left.
3. Move stitch width selector to 0 and take a
few stitches to fasten threads.
• Pull thread ends through to back of
garment knot close to fabric and snip off
loose ends of thread.
63