Performance checklist – SINGER 2210 Athena User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Performance Checklist
If sewing ciifficullies occur, make sure the instructions are cofrectly foNoweck if
a problem still exists, the reminders below may help solve
¡1
Needle Does Not Move
1$ machine connected to electrical
supply?
1$ power and light switch on?
1$ controller connected?
Is bobbin winder disengaged?
Has machine shut off automatically due
to completion of single pattern or but
tonhole?
Needle Moves But Stitch Is Not Formed
Is needle defective?
Is needle fully Inserted into needle
clamp?
Are bobbin and needle correctly
threaded?
1$ bobbin correctly inserted into bobbin
case?
Needle Breaks
Is needle correct si^e?
Is needle fully Inserted in needle clamp?
Are controls properly set?
Are accessories correct for application?
Bobbin Winding Dlificultles
Is threading correct?
Is thread unwinding freely from spool?
Is bobbin wifKier engaged?
Is thread end securely held at start of
wind?
Upper Thread Breaks
Is machine properly threaded?
is thread freely unwinding from spool?
Is proper size spool holder being used?
Is upper thread tension too tight?
Is bobbin case properly inserted?
Is bobbin rim free of nicks?
lower Thread Breaks
Is bobbin correctly wound?
1$ bobbin in case correctly inserted into
bobbin case?
1$ bobbin case threaded correctly?
Skipped Stitches
Is machine properly threaded?
Is fabric firmly held down?
Is needle correct size and style?
Is needle straight and sharp?
Fabric Does Not Move Properly Under
Presser Foot
Is presser foot correctly attached to
machine?
Is presser foot lowered?
Is stitch length correctly set?
Is correct presser foot being used?
44